Glass Core Substrates for Next-Gen SiP & 2.5D/3D Semiconductor Packaging
Dr. Lin Chen
Principal Packaging Architect
1. Through-Glass Via (TGV) Pitch & Electrical Performance
Glass substrates feature an isotropic dielectric constant (Dk ~5.2) and ultra-low loss tangent (Df <0.003 at 50 GHz), making them vastly superior to standard BT resins and Ajinomoto Build-up Films (ABF) for high-speed serialized data channels.
Laser-induced deep etching (LIDE) enables TGVs with aspect ratios exceeding 10:1 and diameters down to 20µm at 50µm pitch, allowing high-density signal breakout without parasitic capacitive loading.
Key Engineering Takeaways
- Through-glass via aspect ratios exceed 10:1 with sub-micron sidewall roughness.
- Ultra-low dielectric loss ensures signal transmission integrity up to 100 GHz RF and optical modulation.
2. Thermal Expansion Matching and Silicon Die Coplanarity
A primary failure mechanism in large-area SiP assemblies (>70x70mm) is shear stress on micro-bumps caused by CTE mismatch between silicon (2.6 ppm/°C) and organic cores (12-16 ppm/°C).
Engineered borosilicate and aluminosilicate glass cores closely match silicon at 3.2-3.8 ppm/°C, virtually eliminating die-attach shear strain and enabling reliable flip-chip assembly of sub-40µm micro-bump arrays.
Key Engineering Takeaways
- CTE matching (3.5 ppm/°C) reduces micro-bump shear stress by over 65%.
- Near-zero panel warpage enables higher yield during SMT reflow and capillary underfill dispensing.
Glass Core Substrate vs. Organic ABF Benchmark
Comparative material and electrical parameters for high-density advanced packaging.
| Parameter / Metric | Standard Organic (ABF) | Advanced Glass Core | Engineering Notes |
|---|---|---|---|
| Coefficient of Thermal Expansion (CTE) | 14 - 18 ppm/°C | 3.2 - 3.8 ppm/°C (Matched to Si) | Drastically reduces solder fatigue in large dies |
| TGV / Microvia Aspect Ratio | 1:1 to 2:1 mechanically drilled | > 10:1 laser-etched TGV | Sub-25µm diameter vias at 50µm pitch |
| Dielectric Loss (Df @ 28 GHz) | 0.012 - 0.018 | < 0.003 | Essential for 112G and 224G SerDes channels |
Need Prototype for this Design?
Turn your high-speed schematics into reality with ChipPCBA. Automated DFM, fast turnaround from 24h, and IPC Class 2/3 inspection standard. Free DFM analysis with every instant quotation.
Related Engineering Articles
View allChipPCBA Unveils SiP (System-in-Package) & 2.5D Substrate Quick-Turn Prototyping Capability
ChipPCBA commissions ultra-fine line 10µm/10µm semi-additive process (mSAP) lines and sub-50µm micro-bump flip-chip packaging for rapid SiP module turnaround.
PCIe 6.0 & PAM4 High-Speed Design: 32+ Layer Stackup, Loss Budget & Surface Roughness Compensation
Comprehensive analysis of PAM4 4-level modulation loss budgets, Megtron 7 dielectric selection, copper foil roughness compensation, and backdrill stub resonance elimination for 64 GT/s channels.
Design for Assembly (DFA): Best Practices for 0.25mm Pitch BGA and 01005 Components
Essential solder paste aperture ratios, pad land patterns, solder mask dam clearances, and thermal relief design for 0.25mm Pitch BGA and ultra-fine pitch components.